Motor into the water after the maintenance method

Immediately after the motor by the water or water, need to check repair, remove the moisture, impurities, in order to prevent the permanent magnet generator motor damaged or destroyed. To fill the agricultural motor should be motor spare parts in accordance with the following four steps overhaul. 1, outside of the wholesalemotor.blogspot.com sludge, impurity removal motor, but do not turn the motor shaft. 2, open motor body, clean up the shell lumen, rotor, and the dirt and stains on the slip ring, check whether the winding is to take off the welding, brush whether rust stuck in the brush holder, brush pressure is normal, whether the brush and slip ring surface tiejin, if discover fault should be ruled out. 3, to dry the winding of the motor. Available incandescent lamp baking, make the moisture evaporation, also can be put in ventilated place dry naturally. But not with the current heat or open flame baking, in case of motor winding short circuit or bad insulation layer. After drying, need a megohmmeter or multimeter to check the coil insulation performance. Found to be defective insulation should be maintenance. 4, www.facebook.com/guohong.trading the motor body refitted, the test run of the motor. Such as test run without any problems, you can put to use.